Table of Contents
Advertisement
S
S
UPER
ERVER 2026T-6RFT+/6RF+ User's Manual
Figure 6-1. Chassis: Front and Rear Views
Control Panel
Power Supplies
IPMI LAN
Mouse/Keyboard Ports
Note: the 10G Ethernet ports are included on the 2026T-6RFT+ only.
6-2
Control Panel
The control panel (located on the front of the chassis) must be connected to the JF1
connector on the serverboard to provide you with system status indications. These
wires have been bundled together as a ribbon cable to simplify the connection.
Connect the cable from JF1 on the serverboard to the appropriate header on the
Control Panel PCB (printed circuit board). Make sure the red wire plugs into pin 1
on both connectors. Pull all excess cabling out of the airfl ow path.
The control panel LEDs inform you of system status. See "Chapter 3: System In-
terface" for details on the LEDs and the control panel buttons. Details on JF1 can
be found in "Chapter 5: Advanced Serverboard Setup."
Slim DVD-ROM
SATA Drive Bays (4)
USB Ports
VGA Port
COM1 Port
1G Ethernet Ports 10G Ethernet Ports
6-2
Control Panel
PCI Expansion Slots (w/riser card)
Advertisement
Table of Contents
