Alarm Lock Trilogy DL4100 Programming Instructions Manual page 20

CLOCK ADJUST
Clock Adjust
Number of seconds to adjust (speed up/slow down) the clock each day must be between
0-55 seconds.
Always consider the current setting when using this function, because this function is not
cumulative. For example, if the clock needs to be sped up 10 seconds per day and the
current setting is already 10, program 20 seconds using Function 43 (below).
Example 1: Clock is losing 13 seconds every day, enter:
1 3
This example assumes that the Clock Adjust setting was at the factory default of zero.
Function 57 can be used to print the current Clock Adjust setting.
Example 2: Clock is gaining 13 seconds every day, enter:
This example assumes that the Clock Adjust setting was at the factory default of zero.
Function 57 can be used to print the current Clock Adjust setting.
Example 3: To set the clock adjust setting back to the factory default of zero, enter:
3 3 3 3 or
NOTE: Subsequent use of these functions are not cumulative.
43. Speed Up Clock
(This Function enabled through keypad only)
44. Slow Down Clock
(This Function enabled through keypad only)
PASSAGE MODE
Passage Mode Enable/Disable - Schedule will Override
1 Function 45 allows passage through the door without the need for a User Code. Re-Lock using Function 46.
1 Programmed Schedules wij| override the state of the lock when Functions 45 and 46 are used. If it is required that
programmed schedules do not override Passage Mode, enable/disable Passage Mode using Functions 48/49. Note: Be­
cause of the temporary nature of these features, Functions 45-47 can only be enabled using the keypad.
45. Enable Passage Mode
(This Function enabled through keypad only)
46. Disable Passage Mode
(This Function enabled through keypad only)
47. Timed Passage Mode
(This Function enabled through keypad only)
• Hours must be between 1 - 999.
Function 47 allows passage through the door without the need for a User Code for the programmed amount of time.
• For example, if you wish your office door lock to be unlocked (unlocked = "Passage Mode") for the next 3 hours,
enter Program Mode and press: II^ O IIQ ^III^P l II^ O ll^ ^ lll^ 0 I I Q ^ I IICPl
20
Programming Functions (cont'd)
1 ^ 1 1 3 3 .
1 ^ 1 1 3 1 3
3
3 3 3
1^^ 1^^
3 [ ___ ]
(seconds)
1^^ 1^^ 1^^
3 [ ___ ]
(seconds)
3
4 7 3 [ _____] 3
(XXX Hours)
4
3
3
2