Power Probe I & Ii Instructions; Hook-Up And Quick Self-Test; Conexiones Y Auto Prueba Rápida - Power Probe ECT 2000 Instruction Manual

Professional electrical tester
Hide thumbs Also See for ECT 2000:
Table of Contents

Advertisement

Hook-up
Unroll the Power Probe cable.
Clamp the RED battery hook-up clip to the POSITIVE terminal of the vehicle's battery.
Clamp the BLACK battery hook-up clip to the NEGATIVE terminal of the vehicle's battery.
Quick self-test
Rock the power switch forward (+), the LED indicator should light RED.
Rock the power switch rearward (-), the LED indicator should light GREEN.
The Power Probe is now ready to use.
If the indicator did not light, depress the reset button of the circuit breaker on the right side of the housing and try the
self test again
Conexión
Desenrolle el cable de prueba del Power Probe.
Conecte el cable ROJO por medio de la pinza a la terminal POSITIVA de la batería del vehículo.
Conecte el cable NEGRO por medio de la pinza a la terminal NEGATIVA de la batería del vehículo.
Auto Prueba Rápida
Mueva el interruptor de potencia adelante (+), el (diodo emisor de luz) LED debe encenderse ROJO.
Mueva el interruptor hacía atrás (-), el (diodo emisor de luz) LED debe encenderse VERDE.
Ahora el Power Probe esta listo para usarse.
POWER PROBE I & II
4

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ECT 2000 and is the answer not in the manual?

This manual is also suitable for:

Power probe iPower probe ii

Table of Contents

Save PDF