The Power Probe negative battery hook-up lead and auxiliary ground lead are connected directly through the Power
Probe. By leaving the positive hook-up disconnected from the vehicle's battery, the Power Probe can be used as a
long jumper lead.
Be careful to avoid short circuits and overloading when
using this jumper function. The leads, in this config-
uration, are NOT protected by the Power Probe's circuit
breaker.
El cable negativo de batería y el auxiliar del Power Probe están conectados directamente a través del mismo Power
Probe. Si dejamos el cable y pinza positivo (+) desconectados en la batería del vehículo, el Power Probe puede ser
usando como un puente.
Tenga cuidado y evite cortos circuitos y sobre carga cuando use función de puente. Los cables, al ser conectados
como se muestran, el fusible no protége.
Positive hook-up clip hangs loose.
Clip positivo (ROJO) suelto.
11
Jumper lead feature
Función de Puente
Motor
POWER PROBE I &II
Need help?
Do you have a question about the ECT 2000 and is the answer not in the manual?