Putting The Blood-Pressure Monitor Into Operation; Inserting The Batteries; Using A Mains Adapter; Tube Connection - Microlife BP 3BTO-A Instruction Manual

4.

Putting the blood-pressure monitor into operation

4.1. Inserting the batteries

After you have unpacked your device, first insert the batteries. The
battery compartment is located on the back side of the device (see
illustration).
a) Remove cover as illustrated
b) Insert the batteries (4 x size AA 1,5 V), thereby observing
the indicated polarity.
c) If the battery warning appears in the display, the batteries
are empty and must be replaced by new ones.
Attention!
• After the battery warning appears, the device is blocked until the
batteries have been replaced.
• Please use «AA» Long-Life or Alkaline 1.5V Batteries. The use of 1.2V
Accumulators is not recommended.
• If the blood-pressure monitor is left unused for long periods, please
remove the batteries from the device.
Functional check: Hold on the O/I button down to test all the display elements. When functioning
correctly all segments must appear.
4.2. Using a mains adapter (special accessory)
It is possible to operate this blood-pressure instrument through a mains adapter (output 6V DC / 600 mA
with DIN plug). Make certain that you use a mains adapter which fulfils the legal requirements (CE sign).
a) Plug the plug into the socket at the left side of the
instrument.
b) Plug the mains adapter into a 230/110 V power socket.
c) Test that power is available by pressing the O/I button.
Note:
• No power is taken from the batteries while the mains adaptor is connected to the instrument.
• If the mains voltage is interrupted during the measurement (e.g. by removal of the mains adaptor from
the mains socket), the instrument must be reset by removing the DIN plug from its socket.
• Please consult a specialist dealer if you have questions relating to the mains adaptor.

4.3. Tube connection

Insert the cuff tube into the opening provided on the left
side of the instrument, as shown in the diagram.
5