NEC Generation N3000 M760s User Manual page 93

•
Hold the SO-DIMM module at a 60-degree angle and align the SO-DIMM connector with the
slot (B) in the system. Push the connector into the slot.
•
Press down on the edge of the SO-DIMM module until the locking tabs on the sides (A) snap into
place, securing the module.
Note:
To remove a SO-DIMM module (C), press the locking tabs (A) away from the sides
of the module until the module pops up. Then, remove the SO-DIMM module.
10.
Replace the bay cover.
11.
Secure the three screws that were removed during step 5.
12.
Install the battery.
13.
Connect the AC adapter to the computer and to the wall outlet and power on the system.
The additional memory is automatically detected and system configuration information are updated.
You can check the amount of memory installed as follows:
•
Windows Vista
© 2007-2009, NEC Computers S.A.S. All rights reserved.
Configuring and Upgrading Your Computer
® : Start, Control Panel, System and Maintenance, then System.
93