Cable Connection; Connecting The Fiber Optic Cables - Fujitsu XG1200 Hardware Manual

2-3

Cable Connection

This section explains how to connect the fiber optic cables and power cords.

2-3-1 Connecting the fiber optic cables

The fiber optic cables need to be connected to the XG1200's Xenpak modules.
1.
Connect the fiber optic cables to the XG1200.
Connect the fibre optic cables to the Xenpak modules Port 1 - Port 12 on the front.
Console RS-232
Mng-LAN
Port 5
Attention Attention
An fiber optic connector is used when connecting two fiber optic cables. When
•
connectors such as these are used, it is important that they be connected cor-
rectly.
If a connector is misconnected, or cleaned incorrectly, it can be damaged. If the
•
fiber optic connector is dirty or damaged, data transmission may become error-
prone and/or unstable.
It is necessary that the connectors be fixed in the correct position, in order to pro-
•
tect the connector interface against external influences.
Connection quality is influenced by two factors: the type of connector and whether
•
it is properly cleaned and connected. Optical losses are often caused by dirty fiber
connectors. Always keep your connectors clean and protect them with a dust
power plug or cover if they are not being used.
Before connecting any cables or connectors, use an lint-free alcohol pad
•
(included in the cleaning kit) to clean the ferrule, the protective tube, and the end
of the fiber core. If a large light loss is detected, and the cause is not immediately
clear, clean the connector as a first attempt to resolve the problem.
Port 10 Port 11 Port 12
Port 9
Tx Rx Tx Rx Tx Rx Tx
Tx Rx Tx Rx Tx Rx Tx
Tx Rx Tx Rx Tx Rx Tx
Port 6
Port 7 Port 8
Port 1
Port 2 Port 3 Port 4
Rx
Rx
Link/Act
FAN
Rx Link/Act

Cable Connection

2
29