Control Panel; Menu Navigation; Address Selection - Martin CX-10 Extreme User Manual

C
ONTROL
You set the address and personalities, read out data, and execute service utilities from the control panel.
Settings can also be changed remotely via the serial link with the Martin MP-2 uploader.
There are four small symbols that can appear in the control panel display:

Menu navigation

See also the control menu table starting on page 34.
The DMX address and any error messages are displayed after the fixture resets. To enter the menu, press
[menu]. Use the [up] and [down] keys to move within the menu. To select a function or submenu, press
[enter]. To escape a function or menu, press [menu].
AddR

Address selection

The CX-10 requires 10 channels for DMX control. The address, also known as the start channel, is the first
channel used to receive instructions from the controller. For independent control, each fixture must be
assigned its own address and non-overlapping control channels. Two CX-10s can share the same address
P
ANEL
Power is on and the fixture is ready.
The fixture is writing to memory. Do not power off the fixture while this symbol is
lit.
The fixture is receiving DMX.
Error. See "Error messages" on page 37 and "Troubleshooting" on page 38.
PERS dFSE INFO
dISP FACT TIME
HRS
dINT
L HR
L ST
dLOF
dRES VER
ALON
SCUT
WHEL
Address/
Messages
dMXL MAN TSEQ
RATE RST
qUAL L ON
STCO
LoFF
SHUT
SHUT
dIM
....
COL
EFSP
EFCT
FOC

Control Panel

UTIL
RUN AdJ
CAL
dFOF
PCbT
UPLd
9