Martin CX-10 Extreme User Manual page 17

R E P L A C I N G A N E F F E C T F L A G
1 Disconnect the fixture from AC power and allow it to cool.
2 Remove the cover.
3 Turn the effect wheel to access the desired position. Press the effect flag
forwards slightly to release it and then grasp it by the edges and remove.
4 To insert an effect flag, slide it under the retention spring until it snaps into
place.
5 Replace the cover before applying power.
G O B O O R I E N T A T I O N
Figure 2 shows the correct orientation for different gobo types. When in doubt, install gobos with the more
reflective side towards the lamp.
Coated side towards lamp
When an object is held up to the
coated side there is no space between
the object and its reflection. The back
edge of the gobo cannot be seen
when looking through the coated side.
Smooth side away from wheel
Reflective side towards lamp
Reversed image towards lamp
Uncoated side towards stage
When an object is held up to the
uncoated side there is a space between
the object and its reflection. The back
edge of the gobo can be seen when
looking through the uncoated side.
Textured side towards wheel
Black side towards stage
True image towards stage
Figure 2: Gobo orientation
Optical configuration 17