Vibration Alarm; Sos Alarm - Concox GT300 User Manual

terminal (must be the SOS number). And it will automatically reply "OK" if set successfully.
NOTE:
When the vibration alarm is off, the arm function will not be executed.

5.2 Vibration Alarm

When the terminal is in arm state, there will be a vibration alarm sent to the SOS numbers in 10s if it detects
vibration.
If the GPS is located, the terminal will send accurate address information. If GPS is not located, the terminal will
send LBS address information instead. And if GPS is located in 5 minutes later, the terminal will send accurate
address information.
e.g. GPS address information:
"vibration alarm: Bao'an Road, Bao'an District, Shenzhen, Guangdong (N22.57139,E113.87710)
e.g. LBS address information:
"vibration alarm: nearby Bao'an Road Bao'an District, Shenzhen, Guangdong (22.571,113.876)".
When vibration alarm is on and GPS is located successfully but there is no GPS connection, the terminal will send
longitude and latitude location to pre-set SOS numbers. When the GPS is not located and there is no GPRS
connection, then the terminal will not get any location information so it will send "Vibration alarm! Please
notice." To pre-set SOS numbers.
NOTE:
The interval of vibration alarm could not be less than 5 minutes. If could not send messages, please check your
SIM card balance.

5.3 SOS Alarm

Press SOS button for more than 3s to activate SOS alarm, meanwhile you could feel the vibration twice, and then
the terminal will send an address information message to the SOS number. If GPS is located, the terminal will
send accurate address information.
e.g.: "Emergency call (LBS): Bao'an Road, Bao'an District, Shenzhen, Guangdong (N22.57139,E113.87710)".
If GPS is not located, the terminal will send a LBS location information.
e.g.: "Emergency call (LBS): nearby Bao'an Road Bao'an District, Shenzhen, Guangdong (22.571,113.876)".
Then it will dial the SOS numbers in cycle, if any SOS number answer the call, it will stop calling. If there's no
response after all the number been dialed for three cycles, it will stop.
If the GPS is located, but the GPRS connection between the terminal and platform is abnormal, then the terminal
will reply to the SOS with the website of the longitude and latitude information.
e.g. SOS! <01-08 17:36>http://maps.google.com/maps?q=N22.577156,E113,916748"
If the GPS is not located, and the GPRS connection between the terminal and platform is abnormal, then the
terminal will not able to get the location information. It will reply to SOS number: "SOS Alarm! Please pay
attention!"
NOTE:
SOS number needs to be set in advance.