Master/Slave Configuration - ADJ WiFLY EXR QA5 IP User Instructions

WiFly EXR QA5 IP
Master-Slave Configuration:
This function will allows you to link units together to run in a Master-
Slave setup. In a Master-Slave set up one unit will act as the control-
ling unit and the others will react to the controlling units built-in pro-
grams. Any unit can act as a Master or as a Slave however, only one
unit can be programmed to act as the "Master."
Master-Slave Connections and Settings:
1. Daisy chain your units via the XLR connector on the rear of the
unit. Use standard XLR data cables to link your units together.
Remember that the Male XLR connector is the input and the
Female XLR connector is the ouput. The first unit in the chain
(master) will use the female XLR connector only. The last unit in
the chain will use the male XLR connector only.
2. Set the "Master" unit to your desired mode of operation.
3. On the "Slave" units press the MODE button until "Slave Mode" is
displayed. The unit is now set as the "Slave" unit. Each slave unit
must be set to the same setting.
4. Connect the first "Slave" unit to the "Master", and the "Slave" unit
should now start to follow the "Master".
ADJ Products, LLC - www.adj.com - WiFly EXR QA5 IP User Manual Page 18
Master-Slave Configuration WiFly EXR QA5 IP
With this feature you are able to control the unit with DMX without the
need of XLR cables. Your DMX controller must be connected to a ADJ
WiFly Transceiver to use this function. You are able to communicate
up to 2500 feet/760 meters (open line of sight).
1. Follow the instructions on pages 15-16 to set the WiFly address
and to activate WiFly. The address must match the address set
on the WiFly WiFly Transceiver.
2. After you have set the WiFly address, follow the DMX instructions
on page 14 to select your desired DMX Channel mode and set
your DMX address.
3. Apply power to the ADJ WiFly Transceiver. The fixture must be set
up first before you apply power to WiFly Transceiver.
4. If everything is set up properly and the fixture is receiving a
Wireless signal, you should now be able to control it with a DMX
controller.
WiFly EXR QA5 IP
This feature will let you link units to run in a master-slave mode with-
out the use of XLR cables.
1. Follow the instructions on pages 15-16 to set the WiFly address
and to activate WiFly. The addresses on each fixture must be the
same.
2. After you have set the WiFly address, select your "Master" unit
and set your desired operating mode.
3. For the "Slave" unit(s), put the unit in Slave mode. See page 12
Master-Slave configuration when setting the unit as a Slave.
4. If everything is set up correctly, the "Slave" units will start follow-
ing the "Master" unit.
ADJ Products, LLC - www.adj.com - WiFly EXR QA5 IP User Manual Page 19
WiFly Set Up
WiFly Master-Slave Set Up