Master/Slave Configuration - ADJ INNO COLOR BEAM QUAD 7 User Instructions

Inno Color Beam Quad 7
To enter the Pan/Tilt Submenu, press the ENTER button for at
least 5 seconds. This submenu allows you to adjust the original
position of the Pan and Tilt.
PAN OFFSET
- In this submenu you can adjust the Pan
home position.
1. Press the MENU button and then press the ENTER button for
at least 5 seconds.
2. Use the UP and DOWN buttons to make your adjustments,
and then press ENTER to confirm. Press the MENU button to
exit without making changes.
TILT OFFSET
- In this submenu you can adjust the Tilt
home position.
1. Press the MENU button and then press the ENTER button for
at least 5 seconds.
2. Use the UP and DOWN buttons to make your adjustments,
and then press ENTER to confirm. Press the MENU button to
exit without making changes.
ADJ Products, LLC - www.adj.com - Inno Color Beam Quad 7 User Manual Page 14
Pan & Tilt Adjustment Inno Color Beam Quad 7
Universal DMX Control:
universal DMX-512 controller to control the chases and patterns,
dimmer and strobe. A DMX controller allows you to create unique
programs tailored to your individual needs. The Inno Color Beam
Quad 7 has 2 DMX channel modes; a 1 Channel Mode & 13 Channel
Mode. To select your channel mode see page 8.
1. This function will allow you to control each individual fixture's
traits with a standard DMX 512 controller such as the
Elation Show Designer™ or the Elation
®
2. To run your fixture in DMX mode, select your desired channel
mode and then set your desired DMX address following the
directions on page 8, and the set-up specifications that come
with your DMX controller.
3. Plug in the fixture via the XLR connections to any standard DMX
controller.
4. For longer cable runs (more than a 100 feet) use a terminator on
the last fixture.
Inno Color Beam Quad 7
Master-Slave Configuration:
to 16 units together and operate without a controller. The units will be
sound activated. In Master-Slave operation one unit will act as the con-
trolling unit and the others will react to the controlling units programs.
Any unit can act as a Master or as a Slave.
1. Using approved DMX data cables, daisy chain your units togeth-
er via the XLR connector on the rear of the units. Remember the
Male XLR connector is the input and the Female XLR connector
is the output. The first unit in the chain (master) will use the female
XLR connector only - The last unit in the chain will use the male
XLR connector only. For longer cable runs we suggest a termina-
tor at the last fixture.
2. Set the Master unit to your desired operating mode.
3. On the slave units tap the MENU button until "Slave Mode" is dis-
played, and Press ENTER. Choose either "Slave 1" or "Slave 2"
and press ENTER. See page 9 for more info.
4. The slave units will now follow the Master unit.
ADJ Products, LLC - www.adj.com - Inno Color Beam Quad 7 User Manual Page 15
Universal DMX Control
This function allows you to use a Elation
DMX Operator.™
®
Master-Slave Configuration
This function will allow you to link up
®