ADJ WiFLY EXR QA5 IP User Instructions page 9

WiFly EXR QA5 IP
tion (On) or deactivate it (Off).
WiFLY Address Setting/WiFly On/Off:
This function is used to set the WiFly address and activate/deactivate
the WiFly function. The address must match the address that is set to
your WiFly TransCeiver or WiFly controller.
1. Plug the fixture in and press the MODE button until "WIFI SET
ADDR: XX" is displayed. "XX" represents a number between
00-14.
2. Use the UP or DOWN buttons to find and set your desired WiFly
address. The address must match the address that is set to your
WiFly TransCeiver or WiFly controller.
3. After you have found and set your WiFly address, press the SET
UP button to activate WiFly. "WIFI SET STAT: XXX" will now be
displayed. Use the UP or DOWN button to set the display to "On"
to activate WiFly. To deactivate WiFly set the display to "Off".
DMX State:
This mode can be used as a precaution mode, that in case the DMX
signal is lost, the operating mode chosen in the setup is the running
mode the fixture will go into when the DMX signal is lost. You can also
set this as the operating mode you would like the unit to return to when
power is applied.
1. Plug the fixture in and press the MODE button until "DMX MODE
ADDR:XXX" is displayed.
2. Press the SET UP button until "DMX MODE NO: XXXX" is dis-
played. "XXXX" represents the current DMX state that is displayed.
3. Use the UP or DOWN buttons to select the operating mode you
would like the unit to start up in when power is applied or the
DMX signal is lost.
• AUTO - If the DMX signal is lost or power is applied, the unit will auto-
matically into Auto Run.
• BLACK - If the DMX signal is lost or power is applied, the unit will
automatically go into stand by mode.
• HOLD - If the DMX signal is lost the fixture will stay in the last DMX
set up. If power is applied and this mode is set, the unit will automati-
ADJ Products, LLC - www.adj.com - WiFly EXR QA5 IP User Manual Page 16
Operating Instructions WiFly EXR QA5 IP
cally go into the last DMX set up.
Dimmer Curve Setting:
This is used to set the dimming curve used with DMX mode. See
page 29 for the different dimming curves.
1. Plug the fixture in and press the MODE button until "DMX MODE
ADDR:XXX" is displayed.
2. Press the SET UP button until "DELAY:X" is displayed. "X" repre-
sents the displayed dimmer curve (0-4).
• 0 - Standard
• 1 - Stage
• 2 - TV
• 3 - Architectural
• 4 - Theatre
3. Press the UP or DOWN buttons to scroll through and select your
desired dimming curve
ADJ Products, LLC - www.adj.com - WiFly EXR QA5 IP User Manual Page 17
Operating Instructions