Master/Slave Configuration - ADJ COB CANNON WASH User Instructions

COB Cannon Wash
This function will allows you to link units together to run in a Master-
Slave mode. In a Master-Slave set up one unit will act as the control-
ling unit and the others will react to the controlling units built-in pro-
grams. Any unit can act as a Master or as a Slave however, only one
unit can be programmed to act as the "Master."
Master-Slave Connections and Settings:
1. Daisy chain your units via the XLR connector on the rear of
the unit. Use standard XLR data cables to link your units together.
Remember that the Male XLR connector is the input and the
Female XLR connector is the ouput. The first unit in the chain
(master) will use the female XLR connector only. The last unit in
the chain will use the male XLR connector only.
2. Set the "Master" unit to your desired mode of operation.
3. On the "Slave" units press the MODE button until "SLAu" is dis-
played. Each "Slave" unit must be set to the same setting.
4. Connect the first "Slave" unit to the "Master." The "Slave" unit(s)
should now start following the "Master" unit.
ADJ Products, LLC - www.adj.com - COB Cannon Wash User Manual Page 12
Master-Slave Configuration COB Cannon Wash
The ADJ RFC remote (sold seperately) has many different functions
and allows you to control your COB Cannon Wash from long distance.
The ADJ RFC remote can control your system up to 150 ft. To use the
RFC you must first activate the fixtures receiver, to activate the receiver
please see the instructions on page 11.
BLACKOUT - Pressing this button will blackout the fixture. Press this
button for more then 3 seconds to activate default mode. All modes will
return to their default settings.
AUTO RUN - This button lets you cycle through color fade mode, color
change mode, and auto run mode. Each press of the button will change
to the next mode. Color fade mode and color change mode have 16 dif-
ferent programs. You can use the "+" and "-" buttons to cycle through
the 16 programs. You can control the speeds of each mode by pressing
the SPEED button and then using the "+" and "-" buttons to adjust the
speed.
SELECTION PROGRAM - Press this button to activate Static Color
mode. Use the "+" and "-" buttons to scroll through the 64 colors. Once
you have found your desired color press the FLASH button to activate
strobing. Use the "+" and "-" buttons adjust the strobe speed.
FLASH - This button will activate the flash (strobe) effect. You can con-
trol the flash speed by pressing the "+" and "-" buttons.
SPEED - Press this button and use the "+" & "-" buttons to adjust the
speed of the color fade mode, color change mode, and auto run.
SOUND ACTIVE - This button activates sound active mode. Use the "+"
& "-" buttons to scroll through the 16 sound active modes and find your
desired mode. Press the SOUND ACTIVE button again to access sound
sensitivity adjustment. Use the "+" & "-" buttons to adjust the sound sen-
sitivity level.
R G B W/A - Press either one of these buttons and the press the "+" or
"-" to adjust the brightness. Press the Flash button to activate strobing
and use the "+" or "-" buttons to adjust the strobe speed.
"+" and "-" - These buttons are used to adjust the flash rate, auto run
speed, color fade speed, color change speed, sound sensitivity, and
output intensity. These buttons are also used to scroll through the static
colors, color fade programs, color change programs, and sound active
programs.
ADJ Products, LLC - www.adj.com - COB Cannon Wash User Manual Page 13
ADJ RFC Operation