C O N T E N T S General Information Limited Warranty Safety Guidelines Overview Installation Remote Control Maintenance Guidelines Troubleshooting | FAQ Specifications Optional Accessories...
G E N E R A L I N F O R M AT I O N INTRODUCTION Please read and understand the instructions in this manual carefully and thoroughly before attempting to operate this device. These instructions contain important safety and use information. This product is intended for use by professionally trained personnel only, and is not suitable for private use.
Page 5
C U S T O M E R S U P P O R T ADJ® provides a customer support line, to provide set up help and to answer any question should you encounter problems during your set up or initial operation. You may also visit us on the web at www.adj.com for any comments or suggestions.
All shipping charges must be pre-paid. If the requested repairs or service (including parts replacement) are within the terms of this warranty, ADJ Products, LLC will pay return shipping charges only to a designated point within the United States. If the entire instrument is sent, it must be shipped in its original package. No accessories should be shipped with the product.
S A F E T Y G U I D E L I N E S To guarantee a smooth operation, it is important to follow all instructions and guidelines in this manual. Elation Professional is not responsible for injury and/or damages resulting from the misuse of this fixture due to the disregard of the information printed in this manual.
Page 8
S A F E T Y G U I D E L I N E S DO NOT position stand close to any FLAMMABLE MATERIALS while operating. DO NOT attempt installation and/or operation of stand without knowledge how to do so. DO NOT permit operation by persons who are not qualified to operate th ese type s of devices.
I N S TA L L AT I O N FLAMMABLE MATERIAL WARNING Keep devices minimum 5.0 feet (1.5m) away from flammable materials and/or pyrotechnics. ELECTRICAL CONNECTIONS A qualified electrician should be used for all electrical connections and/or installations. DO NOT INSTALL THE DEVICES IF YOU ARE NOT QUALIFIED TO DO SO! BEFORE MOUNTING DEVICES, A PROFESSIONAL EQUIPMENT INSTALLER MUST BE CONSULTED.
Page 11
I N S TA L L AT I O N SETUP Turn Knob A counter clockwise to loosen it. Pull up on the lower post to spread the legs until the stays are extended horizontally. Turn Knob B counter clockwise to loosen it. Extend center post to the desired height and insert the safety pin through the stopper in the center post.
Page 12
I N S TA L L AT I O N MOUNTING THE SPEAKER WITHOUT A BRACKET If the speaker (sold separately) has a pole mount socket located on the bottom of the speaker, place the speaker on top of the stand by lowering the speaker onto the center post.
Page 13
I N S TA L L AT I O N CONNECTING THE POWER The Color Stand LED has an included 12V, 3A power-supply. Connect the power supply to the adapter at the mid-section of the stand.
R E M O T E C O N T R O L PAIRING: The original remote that comes in the box is already paired to the unit. In the event that the remote is not paired with the unit, or if pairing to an additional unit, follow the stops below: 1.
M A I N T E N A N C E G U I D E L I N E S DISCONNECT POWER BEFORE PERFORMING ANY MAINTENANCE! CLEANING Frequent cleaning is recommended to insure proper function, optimized light output, and an extended life.
No, the Color Stand LED does not use DMX. 4. What is the maximum height of the stand? The maximum recommended height is 73.68 inches (1,871.5 mm). 5. Are additional stands available? Yes. A variety of stands and accessories are available at www.adj.com.
S P E C I F I C AT I O N S • Height adjustment: 43.2” (1,097mm) to 73.68” (1,871.5mm) • Load Capacity: 60 lbs. (27 kg) • Upper shaft tubing 35mm • Material: Steel + PVC • Includes IR remote •...
Page 18
D I M E N S I O N S Drawings not to scale 39.72” (1,008.9mm) Ø45.87” (Ø1,165.1mm) Specifications subject to change without prior written notice.
O P T I O N A L A C C E S S O R I E S ORDER CODE ITEM CSL100 / 1163000013 Color Stand LED OSL587 O Slim 2 Clamp (Pearl) OSL150 O Slim 1.5 Clamp FCC STATEMENT This device complies with Part 15 of the FCC Rules.