Installation Advice; Technical Informa- Tion For The Installer - Elba P70 Instructions For Use Manual

Installation advice

4
4
IMPORTANT
The appliance should be installed, regulated and adapted to
function with other types of gas by a QUALIFIED INSTAL-
LATION TECHNICIAN.
Failure to comply with this condition will render the guaran-
tee invalid.
The appliance must be installed in compliance with regula-
tions in force.
Installation technicians must comply to current laws in force
concerning ventilation and the evacuation of exhaust gases.
Always unplug the appliance before carrying out any main-
tenance operations or repairs.
TECHNICAL INFORMA-
TION FOR THE INSTALLER
In order to install the cooker top into
the kitchen fixture, a hole with the
dimensions shown in fig. 4.1 has to be
made, bearing in mind the following:
within the fixture, between the
bottom side of the cooker top and
the upper surface of any other
appliance or internal shelf there
must be a clearance of at least 30
mm;
the cooker top must be kept no less
than 200 mm away from any side
wall (fig. 4.1).
the hob must be installed at least
60 mm from the wall.
there must be a distance of at least
650 mm between the hob and any
wall cupboard or extractor hood
positioned immediately above (see
fig. 4.2).
if the hob is installed over a built-in
oven, there must be a distance of at
least 30 mm between the two appli-
ances. The two appliances should
be connected to the gas supply with
independent connections.
INSTALLATION
Fig. 4.1
The appliance must be housed in heat-resistant units.
These tops are designed to be embedded into kitchen
fixtures measuring 600 mm in depth.
The walls of the units must not be higher than work top
and must be capable of resisting temperatures of 105
°C above room temperature.
Do not instal the appliance near inflammable materials
(eg. curtains).
Fig. 4.2
25