Page 2
In the event of burglary, 24-hour or tamper alarm, EWS3 will activate the speakers and flash the blue LED indi- cators, while in case of a fire alarm, the device can flash the red LED indicator (both features require EWS3 Alarm LED and EWS3 Fire Alarm...
Page 3
Speakers for audio alarm indication TAMPER Tamper switches FRONT SIDE of ENCLOSURE ALARM (blue) ALARM (red) ALARM (blue) LED indication Description ALARM (blue) flashing Burglary, 24-Hour or tamper alarm in progress ALARM (red) flashing Fire alarm in progress EWS3 – Wireless Indoor Siren...
Page 4
Ensure to screw in properly for supervision of the back side by tamper switch MOUNTING POINT B 3. When installing EWS3, follow the recommendations for the installation to achieve the strongest wireless signal: Never install in the following Recommended: 0,5 to 30m locations: • face the front side of the...
Page 5
7. Pair the device with the alarm system using ELDES Configuration Tool software. Open Wireless Device Management section and enter a 8-digit wireless device ID located on the EWS3 enclosure and press Add button. The device can also be paired by sending a corresponding command via SMS text message.
Page 6
• one located on the front side of the PCB supervising the front cover in case it is illegally opened (see fig.#1). • the other one located on back of the PCB supervising the back side of the enclosure in case the EWS3 is illegally detached from the wall (see fig.#1).
Page 7
UAB” will not take any responsibility regarding personal or property or revenue loss while using the system. “ELDES UAB” liability according to local laws does not exceed value of the purchased system. “ELDES UAB” is not affiliated with any of the Internet providers therefore is not responsible for the quality of Internet service.
Need help?
Do you have a question about the EWS3 and is the answer not in the manual?
Questions and answers