Wyse S10 Administrator's Manual page 48

42
Chapter 5
•
•
•
•
Use the Touch Screen tab to configure touch screens that are connected to the thin client
(USB). The tab is available (not grayed out) when the thin client detects that a touch
screen is attached through a USB port and the setup (or calibration) has not been
performed. The Touch Setup window prompts you to touch two circles on the screen to
make the necessary calibration adjustment. Once calibrated, the adjustment values are
saved in the local terminal NVRAM until the system is reset to factory default, or another
type of touch monitor is connected.
Size - Character size 5, 6, 7, or 8 bits can be selected (default is 8).
Flow Control - Either None, XON/XOFF, CTS/RTS, or Both can be selected (default
is None).
Serial Touch Screen selections - Select the proper touch screen ELO, MicroTouch or
FastPoint from the list.
Touch Screen on - Select the proper serial port (COM port) or None from the list.