Table of Contents
Advertisement
Configuring Connectivity Options
•
EAP Type - If you have enabled the Enable IEEEE 802.1x authentication check box,
select the EAP Type option you want (TLS, LEAP, or PEAP).
TLS - If you select the TLS option, click Properties to open and configure the
Authentication Properties dialog box (you can use Browse to find and select the
Client Certificate file and Private Key file you want). Note that the CA certificate must
be installed on the thin client.
LEAP - If you select the LEAP option, click Properties to open and configure the
Authentication Properties dialog box (be sure to use the correct Username and
Password for authentication). Note that the maximum length for the username or the
password is 64 characters.
PEAP - If you select the PEAP option, click Properties to open and configure the
Authentication Properties dialog box (be sure to select either EAP_GTC or
EAP_MSCHAPv2, and then use the correct Username, Password, and Domain, if
necessary, for authentication). To configure EAP-GTC, enter the username only, and
the password or PIN will be asked when authenticating. To configure EAP-MSCHAPv2,
enter the username, password, and domain (domain\username in the username box is
supported, but you must leave the domain box blank). Note that the CA certificate must
be installed on the thin client (the server certificate is forced to be validated).
•
Certificate Management - Opens the Certificates Browser where you can select the
Import From option you want to import a certificate (either USB Storage or File
Server).
USB Storage - If you select the USB Storage option, click Import to open and use the
Import dialog box to find and select the certificate you want to use. The maximum
importing path is limited to 128 characters and the maximum certificate name is limited
to 64 characters.
File Server - If you select the File Server option, click Import to open and use the
Import dialog box to enter the detailed path to the certificate you want to use in the File
Servers box (if necessary, be sure to use the correct Username and Password). Note
that you must enter the absolute path of the certificate. For example: 10.151.121.100/
wnos/cacerts/mycertificate.cer. The maximum importing path is limited to 128
characters and the maximum certificate name is limited to 64 characters.
Use the following guidelines for the Wireless tab:
Tip
While Service Set Identification (SSID) and encryption configurations must
be entered in the Wireless tab on the thin client, be sure that the
corresponding entries are also be made on the enterprise access point.
•
SSID - Enter the Service Set Identification (name of the wireless network) set up by the
network administrator for this wireless communication link (maximum is 32 characters).
23
Hide quick links:
Advertisement
Table of Contents
