Pc Card Bay Removal; Removing The Support Plate - NEC POWERMATE 2000 Service And Reference Manual

PC Card Bay Removal

Remove the PC card bay as follows.
Remove the system board and support plate assembly (see "System Board and Support
1.
Plate Assembly Removal" earlier in this section).
Position the assembly with the processor side of the system board facing up. Use care to
prevent damage to the cables on the back side of the board.
Remove the support plate from the system board as follows.
2.
Locate the black plastic shield between the PC card bay and the system board (see the
!
following figure).
Carefully lift the corner of the black shield for access to the screw fastening the support
!
plate to the system board. Do not attempt to remove the shield or you may damage the
shield, bay, or board.
While holding up the corner of the shield, remove the screw.
!
Remove the second support plate screw (see the following figure for screw locations).
!
Lift the system board off the support plate and set the board on a static free surface. Use
!
care to prevent damage to the cables on the board.
A – Support Plate
B – Support Plate Screw
C – System Board

Removing the Support Plate

D – PC Card Bay
E – Plastic Shield
F – Support Plate Screw (under plastic shield)
Disassembly and Reassembly 3-17