Features - DFI BT700 User Manual

Features

• DDR3L
DDR3L is a higher performance DDR3 SDRAM interface providing less voltage and higher
speed successor. DDR3L supporting 1066MHz
system bandwidth and improved performance to provide its higher bandwidth and its increase
in performance at a lower power than DDR3 and DDR2.
• Graphics
The integrated Intel HD graphics engine delivers an excellent blend of graphics performance
®
and features to meet business needs. It provides excellent video and 3D graphics with out-
standing graphics responsiveness. These enhancements deliver the performance and compat-
ibility needed for today's and tomorrow's business applications. Supports HDMI, DVI and DP
interfaces for display outputs.
• Serial ATA
Serial ATA is a storage interface that is compliant with SATA 2.0a specification. With speed of
up to 3Gb/s (SATA 2.0), it improves hard drive performance faster than the standard parallel
ATA whose data transfer rate is 100MB/s.
• Gigabit LAN
The Intel I210AT/IT Gigabit Ethernet Controller
®
• Watchdog Timer
The Watchdog Timer function allows your application to regularly "clear" the system at the set
time interval. If the system hangs or fails to function, it will reset at the set time interval so
that your system will continue to operate.
Chapter 1 Introduction
(-E26/-E15) or 1333MHz (-E45) delivers increased
supports up to 1Gbps data transmission.
Chapter 1
Specification Comparison Table
The table below shows the Qseven standard specifications and the corresponding specifications
supported on the BT700 module.
ARM/RISC Based
System I/O Interface
Minimum Configuration
PCI Express Lanes 0
Serial ATA channels 0
USB 2.0 ports 3
USB 3.0 ports 0
LVDS channels
0
embedded Display Port
DisplayPort, TMDS 0
High Definition
0
Audio/AC'97/I2S
Ethernet 10/100
0
Mbit/Gigabit
UART 0
Low Pin Count bus 0
Secure Digital I/O 8-bit
0
for SD/MMC cards
System Management 0
2 1
I C Bus
SPI Bus 0
CAN Bus 0
Watchdog Trigger 1
Power Button 1
Power Good 1
Reset Button 1
LID Button 0
Sleep Button 0
Suspend To RAM (S3
0
mode)
Wake 0
Battery low alarm 0
Thermal control 0
FAN control 0
7
X86 Based Minimum Maximum DFI BT700
Configuration Configuration Configuration
3+1(shared with
1 (x1 link) 4
Ethernet)
0 2 2
6+2(shared with 1
4 8 USB 3.0 port) - BOM
option
0 2 1
0 Dual Channel 24bits Dual Channel 24bits
0 1 1
0 1 1
0 1 (Gigabit Ethernet) 1
0 1 1
0 1 1
0 1 1
1 1 1
1 1 1
0 1 1
0 1 0
1 1 1
1 1 1
1 1 1
1 1 1
0 1 1
0 1 1
0 1 1
0 1 1
0 1 1
0 1 1
0 1 1
www.dfi .com