Table of Contents
Advertisement
Important:
Electrostatic discharge (ESD) can damage your processor, disk drive and other com-
ponents. Perform the upgrade instruction procedures described at an ESD worksta-
tion only. If such a station is not available, you can provide some ESD protection by
wearing an antistatic wrist strap and attaching it to a metal part of the system chas-
sis. If a wrist strap is unavailable, establish and maintain contact with the system
chassis throughout any procedures requiring ESD protection.
System Memory
The system board is equipped with eight
2GB/4GB DDR3L onboard memory
• Supports DDR3L 1333MHz (-E45/-E27/-J00/-N30/-N07)
Supports DDR3L 1066MHz (-E26/-E25/-E15)
• Supports single channel memory interface
DDR3L
DDR3L
Chapter 2 Hardware Installation
Chapter 2
Cooling Option
Heat Spreader with Heat Sink
inerfaces.
Top View
Bottom View
10
Top View of the Heat Sink
1
2
Bottom View of the Heat Sink
•
"1" and "2" denote the locations of the
thermal pads designed to contact the
corresponding components that are on
BT700.
•
Remove the plastic covering from the
thermal pads prior to mounting the heat
sink onto BT700.
www.dfi .com
Advertisement
Table of Contents
