Device Installation - Illustra IE02MFBNWIY User Manual

Note
Before the installation, please make sure the installation environments can at least support 3x weight of
the camera.
Please see Figure 3-1 and Figure 3-2.
Step 1
Stick installation sticker to designated surface where you will install the device (wall or ceiling).
Step 2
Dig a hole according to position of hole on installation sticker.
Step 3
Open accessories bag, take out expansion bolt and insert it into the hole you just dug.
Step 4
Open accessories bag, take out screw. Tighten the 4 screws to fix the device on the installation surface
(wall or ceiling). You can move device sunshade back and forth. When you have fixed the device, you
must tighten screws on sunshade.
Step 5
Plug external wiring of the device properly.
Figure 3-1 Device installation 1

Device Installation

8