Audio Control - Sanyo CDF-R800 Operating Instructions Manual

Audio Control
r
Audio control mode select button
_ Loudness button
— Audio control button
VOL (Volume) control
Press the ( ~\) side of the Audio control button to increase, or the (~) side to
decrease the volume level. During adjustment, [VOL] appears on the display.
BAS (Bass) / TRE (Treble) / BAL (Balance) / FAD (Fader) control
@ Pressing the Audio control mode select button (~),
select the
desired mode.
With each press the mode shifts to the next setting. See below.
@ Pressing the ( ~\ ) or ( ~ ) side of the Audio control button, adjust the level.
Note:
. Adjust the Bass, Treble, Balance or Fader within 5 seconds after selecting
the Audio control mode (the selected mode indicator appears on the display),
If no mode indicator appears on the display, pressing the ( ~\) or ( ~)
side of the Audio control button will adjust the volume.
Hint:
Press and hold the audio control button to change the level quickly.
Mode shift
'ress u "
Press ~\. Display
7
To
decrease
B~S (Bass)
To
increase
-7-7
T~E (Treble)
To decrease To increase
–7-7
BAL (Balance)
To the left speaker To the right speakers
o-9
F~D (Fader)
To the rear speaker To the front speakers o-9
I
V+OL (Volume)
I I
To decrease To increase
0-19
Note:
With each press, the level changes. But the Audio level shown on the display
does not change with every press. Use it to know the rough level.
Loudness (LOUD)
a
Press the Loudness button ( ,.,O, ) to emphasize the Bass and Treble range at low
listening level. [LOUD] appears on the display.
To
cancel the mode, press the but-
ton again.
8