Sanyo FXCD-1350 Operating Instructions Manual

Sanyo FXCD-1350 Operating Instructions Manual

Fold down design full panel detachable fm stereo/am receiver auto reverse cassette player compact disc player with cd changer controller iso mounting with remote trim ring


Quick Links

Fold Down Design Full Panel Detachable
FM Stereo/AM Receiver
Auto Reverse Cassette Player
Compact Disc Player
With CD Changer Controller
ISO Mounting with Removable Trim Ring

OPERATING INSTRUCTIONS . . . . . . . . . . . . . . . . . . . 1~29

LIBRITO DE INSTRUCCIONES . . . . . . . . . . . . . . . . . 30~57


Table of Contents

Summary of Contents for Sanyo FXCD-1350

  • Page 1: Operating Instructions

    OPERATING INSTRUCTIONS FXCD-1350 Fold Down Design Full Panel Detachable FM Stereo/AM Receiver Auto Reverse Cassette Player Compact Disc Player With CD Changer Controller ISO Mounting with Removable Trim Ring (English) OPERATING INSTRUCTIONS ....1~29 (Español)
  • Page 2 LIMITED WARRANTY In order to obtain warranty service, the product must be delivered to and picked up from an Authorized Sanyo Factory Service Center at the user's expense, unless specifically stated otherwise in this warranty. The names and addresses of Authorized Sanyo Service Center may be obtained by calling the toll-free number listed below.
  • Page 3: Table Of Contents

    • Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. • Changes or modifications not expressly approved by Sanyo may void the user's authority to operate this equipment. English...
  • Page 4: Compact Disc Care

    COMPACT DISC CARE Dirt, dust, scratches and warpage can cause a deterioration in the sound or intermittent skipping some tracks during play. Label Side • This unit has been designed to play compact discs bearing the identification logo shown on the left. Discs bearing other types of identification logos may not play properly.
  • Page 5 Benzene Thinner Cleaning spray • Mixed-mode CDs This product can only play audio tracks on mixed-mode CDs. The initial track contains non-audio data, and so it does not produce any sound. Playback will start from the next track. (Mixed-mode CDs are CDs which contain both non-audio data and audio tracks.) •...
  • Page 6: Remote Controller

    REMOTE CONTROLLER REMOTE CONTROLLER OPERATION PRESET (+) Button Not used • Radio mode: Select a registered station BAND button • CD-CH mode: Change reception band DISC change SCN button • Radio mode: Scan a preset station • CD/CD-CH mode: Play introduction to current DISC •...
  • Page 7: Battery Installation

    BATTERY INSTALLATION Install a lithium battery (CR2025) with the poles facing the correct direction. BATTERY REPLACEMENT TIMING When battery power is depleted, the buttons may not be operable. If the remote controller does not operate, replace the battery and check the operation. CAUTIONS REGARDING BATTERY Be sure to follow the instructions to prevent battery leakage, over-heating, ignition, or explosion.
  • Page 8: Digital Display

    DIGITAL DISPLAY BASS mode Sound mode CD-CH Radio Frequency, Time, AM Band CD Track Number, Error Signs, FM Bands Audio Control Selection, no CD, no Tape, Sound Mode Display Repeat Play Disc Number, Preset Channel, Shuffle ATP Channel Play Disc in Tape playing direction Metal...
  • Page 9: Detachable Front Panel

    DETACHABLE FRONT PANEL The front panel is designed to be removable for antitheft purposes. It is recommended that you remove and carry the front panel with you when you leave your car. A carrying case is provided with the unit for this purpose. HOW TO DETACH THE FRONT PANEL Press the open button to open the door.
  • Page 10: General Operation

    GENERAL OPERATION TURNING THE POWER ON Install the front panel and press the POWER button TURNING THE POWER OFF Press the POWER button to stop the current operation. The button dims when the power is off (ACC on). ELECTRONIC CONTROLS Press the AUDIO button , then press the AUDIO button table below.
  • Page 11 ... 3 BASS CONTROL Press the SOUND button for more than 1.5 second to switch ON/OFF of the BASS mode. When the BASS mode is on, “BASS” is displayed and the bass enhances. RADIO SELECTION BUTTON (BAND) Press the BAND button to switch from CD player, CD changer or tape mode to radio.
  • Page 12: Radio Operation

    RADIO OPERATION SELECTING RADIO MODE Press the BAND button to switch from CD player, CD changer or tape mode to the radio. Each time the BAND button is pressed, the selected band changes as shown below. FMII ... 2 RADIO TUNING •...
  • Page 13 ATP (AUTO TRAVEL PRESET) OPERATION The Auto Travel Preset function searches for and memorizes the 6 strongest stations in one of the two bands (FM, AM) in the order of signal strength. This feature is useful when you are driving in an unfamiliar location and want to memorize local stations without changing the standard preset stations.
  • Page 14: Tape Operation

    TAPE OPERATION 5 11 10 ... 1, 2, 3 LOADING AND EJECTING THE TAPE Press the OPEN button to open the door. Insert a cassette into the tape slot and the tape player will start. Press the eject button to eject a tape. CAUTION •...
  • Page 15 LOCATING THE BEGINNING OF A PROGRAM ... 6, 7, 8 (AMSS) This system is equipped with a function that allows you to skip forward or backward to locate the beginning of a particular selection on the tape. (Automatic Music Select System : AMSS) Press the AMSS button .
  • Page 16: Cd Operation

    CD OPERATION LOADING AND EJECTING THE CD Press the OPEN button to open the door. Insert a disc into the CD slot and the CD player will start. Press the eject button to eject a disc. CAUTION • This CD player is not designed for 8 cm CDs. Please do not use an 8 cm CD nor 8 cm CD adaptor.
  • Page 17 ... 5, 6 SKIPPING TRACKS Press the > button to skip to the beginning of the next track. Press the < button to skip to the beginning of the track currently playing. Press the < button twice to skip to the beginning of the previous track. Press and hold the >...
  • Page 18: Cd Changer Operation

  • Page 19 ... 7 REPEAT MODE • Repeat tracks ... Press the RPT button • Repeat discs ... Press the RPT button To cancel the track repeat or disc repeat mode, press the RPT button or eject the magazine. The system will remain in this mode until it is cancelled. SCAN MODE (PLAYING THE BEGINNING OF TRACKS OR DISCS) This function plays the first 10 seconds of each track or disc sequentially.
  • Page 20: Error Signs

    ERROR SIGNS CD Player If a problem should occur while operating the built-in CD player, one of the following error signs may be displayed: Symptom Abnormal CD mechanism function. The disc was inserted incorrectly. The disc is dirty. The disc is defective. There is condensation on the opti- cal lens.
  • Page 21: Clock

    CLOCK DISPLAY MODE CHANGE The display on the unit can be changed by pressing DISP button between the clock and audio display. When a radio, tape and CD function is performed while the time display is selected, the audio display will appear for 5 seconds, then the display will return to the time mode..
  • Page 22: Hints For Proper And Safe Operation

    Do not leave a disc partially ejected from the player. Servicing • Should a problem develop, do not open the unit or try to repair it yourself. If servicing is required, bring the unit to a Sanyo Authorized Service Center. -21-...
  • Page 23: Troubleshooting

    TROUBLESHOOTING Sometimes a simple operational error or a mistake in the wiring can appear to be a problem with the unit. Before having the unit serviced, refer to the troubleshooting chart below. Symptom The compact disc does not play The volume control is turned when inserted into the unit.
  • Page 24: Accessories And Hardware

    ACCESSORIES AND HARDWARE Mounting Bracket (Half Sleeve) x 1 Removable Trim Ring INSTALLATION 1. BEFORE INSTALLATION When mounting the unit in a car, keep the unit as level as possible. If the unit must be mounted at an angle, due to the design of the vehicle, make sure the unit does not tilt by more than 30°.
  • Page 25 2. ISO MOUNTING WITH REMOVABLE TRIM RING When mounting the unit into a DIN-standard cutout (182 × 53 mm) in the dashboard or console, attach the provided Removable Trim Ring to the unit. 182 mm 53 mm REMOVABLE TRIM RING 3.
  • Page 26 4. Installation to TOYOTA/NISSAN Vehicles Install the unit using the existing TOYOTA/NISSAN Mounting Bracket and Screws. Use mounting holes in the unit chassis. "T" or "N" is engraved next to each mounting hole. Use "T" holes for Toyota vehicles and "N"...
  • Page 27: Unit Removal

    UNIT REMOVAL AUDIO UNIT UNLOCK LEVERS 1. Press the open button to open the door. 2. Pull the right side of the front panel, then pull the left side of the panel to remove it from the unit. 3. Insert the unlock levers into the slots as illustrated in (A). Note The jagged side of the unlock lever should face outward.
  • Page 28: Electrical Connections

    ELECTRICAL CONNECTIONS ANTENNA PLUG 4-speaker System (White) (White/Black) (Gray) (Gray/Black) (Green) (Green/Black) (Violet) (Violet/Black) 2. +12V Constant Power Supply (Yellow) 3. +12V Accessory/Switched (Red) 4. Ground Wire (Black) 5. Power Antenna (Blue/Red) 6. Amplifier Turn On (Blue/White) 7. Sub-Woofer Code (Monaural) CAUTION •...
  • Page 29: Line Out/Cd Changer Connections

    Fuse 15A Burnt LINE OUT/CD CHANGER CONNECTIONS The unit has a built-in CD changer controller and line output terminals. You can use a compatible Sanyo • CD changer and a separate amplifier to upgrade your system. CD Changer...
  • Page 30: Specifications

    Operating Current Maximum ............13A IMPORTANT INFORMATION Because its products are subject to continuous improvement, SANYO reserves the right to modify product designs and specifications without notice and without incurring any obligation.
  • Page 31 21605 Plummer Street 1ED6P10A18800 Printed in Malaysia Chatsworth, CA91311 Rev.0...

Table of Contents