Martin Extube User Manual page 5

P R O T E C T I O N F R O M B U R N S A N D F I R E
• Do not operate the fixture if the ambient temperature (Ta) exceeds 40°
C (104° F).
• The exterior of the fixture becomes hot, up to 75° C (167° F) during
normal operation. Ensure that accidental physical contact with an
installed fixture is impossible.
• Allow the fixture to cool for 20 minutes before servicing.
• Keep combustible materials (for example fabric, wood, paper) at least
0.5 m (20 in.) away from the fixture's front cover and light output. Keep
flammable materials well away from the fixture.
• Do not modify the fixture in any way not described in this manual or
install other than genuine Martin parts. Do not stick filters, masks or
other materials directly onto LEDs. Use only Martin approved
accessories to mask or modify the light beam.
• Do not attempt to bypass thermostatic switches or fuses. Replace
defective fuses with ones of the specified type and rating only.
• Install the fixture in a well ventilated area only. Provide a minimum
clearance of 10 cm (4 inches) and ensure unrestricted airflow around
the fixture.
P R O T E C T I O N F R O M I N J U R Y
• The LED emission presents a hazard to eyesight at distances from 4 cm
(1.6 inches) to 40 cm (16 inches) when the eye is exposed to the beam
for longer than 0.25 seconds.
• Do not look at LEDs from a distance of less than 40 cm (16 inches)
without suitable protective eyewear.
• Do not look at LEDs with a magnifying glass or any other optical
instrument that may concentrate the light output.
• Ensure that all external covers, components and installation fittings are
securely fastened.
• Block access below the work area and work from a stable platform
whenever installing, servicing or moving the fixture.
• Ensure that all supporting structures, surfaces, fasteners and lifting
equipment can bear the weight of all the devices they are intended to
support plus an adequate safety margin, and that they conform to local
building and safety regulations.
• Use a sufficient number of fasteners with sufficient corrosion resistance,
dimensions and strength to mount the DIN rail safely. Any nuts used
must be self-locking.
• If the fixture is to be installed in a location where it may cause injury or
damage if it falls, use a secondary means of attachment such as looped
safety wires passing around the fixture.
Safety Information 5