Installation; Installing The Lamp - SHOWTEC Genesis Scan CDM-150 Product Manual

Installation

Installing the Lamp

The Showtec Genesis Scan uses the CDM 150 (ordercode 80964, 80965, 80974, 80975) bulb as
manufactured by all popular manufacturers. Use only the appropriate lamp for your unit.
Note that, product versions that use other lamps, may be offered in the future. Check your product
specification label for information.
Always disconnect from electric mains power supply before changing lamps.
The lamp has to be replaced when it is damaged or deformed due to the heat.
Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the
device was not designed for.
Damages caused by non-observance are not subject to warranty.
Procedure :
1. Loosen the 4 screws on the back of the housing.
2. Gently remove the metal housing.
3. Read lamp instructions. Do not touch the lamp bulb glass. (See Figure 3.)
Oil on hands shortens the lamp life. (If you touch the bulb glass, wipe off the glass with a clean, lint-free
towel and rubbing alcohol.).
4. Insert the lamp pins into the lamp socket. You can adjust the distance between the lamp and the lens
(screws A, B, C) on the back.
5. Put the metal housing back and fasten the screws snugly.
1
Backside Lamp Board
Fig. 4
6
Fig. 3