ESAB ESP-50 Instruction Manual page 87

SECTIoN 3
Allow at least 10 ft. (3m)
between work and power source
WORK
SAFETY GROUND
CUSTOMER FUSED LINE DISCON-
NECT SWITCH
(See Table 3.1 and WARNING in
regards to chassis ground in Sec-
tion 3.5.)
ACCESS FOR CNC
INTERFACE CONNECTIONS.
(See Detail "A")
Prefiltered AIR SUPPLY
(Customer Supplied)
(100 psig max /6.9 bars max)
NoTE:
figure 3-2. ESP-50 Interconnection Diagram
87
ACCESS DOOR FOR
TORCH CONNECTION
INPUT POWER CABLE
(See Table 3.1)
The 208/230 V models are equipped with a plug for single-
phase connection only. The plug is mounted to a 4-conductor
cable. If 3-phase connection is desired, remove and discard
the plug and refer to Sect. 3.5.
INSTallaTIoN
TORCH
PILOT
ARC
CONNECTION
TORCH
POWER
CABLE
CONNECTION