Replacement Parts - Pentair EVERPURE Twin Installation And Operation Manual

High flow csr filter systems

Hide thumbs

page of 8

/ 8
Bookmarks

INLET

3/4" FNPT

CARTRIDGE CHANGE DETERMINATION

• Replace the prefilter cartridge whenever it becomes

excessively dirty (observed visually or by flow restriction).

Follow the change instructions provided with the

cartridge.

• Replace carbon filter cartridges when capacity is

reached or when flow becomes inadequate, but at least

annually. All carbon filter cartridges on multiple cartridge

systems should be changed at the same time. Change

the Everpure SS-10 cartridge when product level in the

cartridge drops below 1/2" from the bottom of the bowl.

• The system pressure gauge or optional Everguard Low

Pressure Alarm (LPA) provides a quick, simple means

of determining when the filter cartridge(s) should be

checked. Installed on the system outlet manifold, the

gauge or LPA can be used to monitor both dynamic

(flowing) and static (line) pressure.

• The cartridge(s) should be changed when the pressure

gauge is in the red area while equipment is in operation,

and yet the needle shows adequate line pressure between

cycles.

• Observe the needle during the next equipment on cycle.

If the needle registers adequate pressure, it can be

assumed that the temporary low-pressure condition

was caused by a brief power failure or other incoming

pressure disruption.

• If the low pressure condition is not due to an external

condition, check/change the prefilter first. If the low

pressure condition is still not corrected, change the

carbon filter cartridges.

34"

OUTLET

3/4" FNPT

ICE MACHINE/

COFFEE

OUTLET

3/4" FNPT

Figure 7 Quad

HIGH FLOW CSR FILTER SYSTEMS INSTALLATION AND OPERATION GUIDE

INLET

3/4" FNPT

25.69"

FLUSHING

For maximum life, all carbon filter cartridges must be

flushed for five (5) minutes at full flow before use.

ALL NEW CARTRIDGES MUST BE FLUSHED AFTER EACH

CARTRIDGE CHANGE BEFORE BEING PUT INTO SERVICE!

If the cartridges are new, have been properly flushed and

both needle and follower register inadequate pressure, or the

LPA is sounding, you may be experiencing inadequate water

pressure or some restriction may exist in the inlet water

line. In either case, the incoming water pressure must be

improved to receive optimum filter life.

COMPLETE CARTRIDGE CHANGE INSTRUCTIONS CAN BE

FOUND ON THE FILTER CARTRIDGE LABEL.

Not for residential use. For food service applications only.