Advertisement
PRESSURE GAUGES
Low Inlet
Pressure
CARTRIDGE CHANGE PROCEDURE
E-Series Prefilter Cartridge Change
1. Shut off power to equipment. Shut off
inlet water ahead of system.
Everpure Carbon Filter Cartridge
Change
. Shut off power to equipment. Shut off
1
inlet water ahead of system.
SR-X Feeder Cartridge Change
1. Shut off power to equipment. Shut off
inlet water ahead of system.
4
HIGH FLOW CSR FILTER SYSTEMS INSTALLATION AND OPERATION GUIDE
Adequate Inlet
3. Clean bowl with filtered water only; NO
2. Push red relief valve. Unscrew bowl.
4. Feel head o-ring. If dry, lubricate with
Remove prefilter cartridge.
4. Pull cartridge downward and out of head.
2. Open flushing valve to relieve pressure.
5. Hold head firmly. Align cartridge lug with
3. Hold head firmly and push upward. Turn
cartridge to left until it stops.
4. Remove old cartridge.
2. Press red pressure relief button on head.
5. Feel bowl o-ring; if dry, lubricate with
3. Unscrew bowl.
Pressure
SPECIAL CLEANERS.
5. Install new prefilter cartridge in bowl.
high quality silicone lubricant.
6. Turn cartridge right 90˚ until
label. Insert new cartridge firmly
7. Repeat steps 3-6 for remaining
into head.
6. Install new SS-10 cartridge into head.
silicone lubricant.
7. Hand tighten bowl into head.
Low Outlet
Pressure
6. Turn on water. Turn on power to
Hand tighten bowl onto head.
equipment.
Flushing
8. With flushing valve fully open, open inlet
rotation stops.
water at full force for five minutes. Close
flushing valve.
cartridges.
9. Turn on power to equipment
8. Turn on water.
9. Press red pressure relief button until
water comes out of valve port.
10. Turn on power to equipment.
Adequate Outlet
Pressure
Advertisement
