Drive Belt Replacement - Matrix U7XE-05 Bike Service Manual

CHAPTER 9: PART REPLACEMENT GUIDE

9.15 DRIVE BELT REPLACEMENT

1) Remove the side covers as outlined in Section 9.9 (Figure A).
2) Using a hook or loop of wire, remove the spring from the frame (Figure B). The tensioner should now pivot away from the drive belt.
FIGURE A FIGURE B
3) Remove the drive belt (Figure C).
4) Use a straight edge to make sure that the pulley and generator pulley are in a straight line (Figure D). If the belt is not on line, try to adjust
the generator location.
FIGURE C FIGURE D
5) Reverse Steps 1-4 to install a new drive belt. NOTE: Be sure to reattach the tension spring. Rotate the pulley to make sure that the motion
is smooth and that there is no wobbling to one side.
59