Chapter 6: Engineering Mode; Engineering Mode Overview; Engineering Mode - Calibration Tab - Matrix U7XE-05 Bike Service Manual

6.1 ENGINEERING MODE OVERVIEW

The Engineering Mode allows the club owner to keep track of the technical settings and error history for the bike.
1) To enter Engineering Mode, press ENTER, 2, 0, 0, 1, ENTER on the lower display. Engineering Mode will appear on the display (Figure A).
2) Follow the prompts to change the desired setting.
3) Press the ENTER key once the desired setting is correct to save.
4) Press HOME to return to normal operation. NOTE: If a setting has been changed, the unit and console power should be reset. Cycle the
power switch, and press and hold the CHANNEL UP and CHANNEL DOWN keys for 3-5 seconds to reset the console power.

6.2 ENGINEERING MODE - CALIBRATION TAB

ENGINEERING MODE
Calibration
16

CHAPTER 6: ENGINEERING MODE

FUNCTION & DEFAULTS
RPM Low Limit Charge:
Default: 10
RPM Low Limit Resistance
Default: 10
FIGURE A
DESCRIPTIONS
This option controls the RPM low limit to iPod
charge.
This option control the RPM low limit to show
resistance.
MODIFIED
Range: 0 - 255
Range: 0 - 255