Lower Control Board Replacement - Matrix U7XE-05 Bike Service Manual

9.13 LOWER CONTROL BOARD REPLACEMENT

1) Remove the front shrouds as outlined in Section 9.8.
2) Disconnect the 5 wire connections to the lower board (Figure A).
3) Remove the 2 screws holding the lower board to the frame (Figure B), and remove the lower board.
FIGURE A
4) Reverse Steps 1-3 to install a new lower board. Figure C shows the connections at the board.
2 Pin Connector
from the Resistor
3 Pin Connector from
the Generator
5) Test the bike for function as outlined in Section 9.20.
CHAPTER 9: PART REPLACEMENT GUIDE
FIGURE C
FIGURE B
6 Pin Connector from
the DC power source
2 Pin Connector
from the Battery
8 Pin Connector
from the Console
57