Maintenance - Steel City 45925G User Manual

PROTECTING CAST IRON TABLE
FROM RUST
WARNING
MAKE CERTAIN THAT THE SAW IS DISCONNECT-
ED FROM THE POWER SOURCE.
The environment and frequency of human contact can
have a very detrimental impact on unpainted cast iron
surface. Moisture, humidity and oils (from human hands!)
can cause the unpainted cast iron surfaces to mar or rust,
so it is important to conduct routine maintenance to keep
your table saw looking new. Cleaning and waxing the
cast iron surfaces on a regular maintenance schedule is
recommended as follows:
To clean and maintain the unpained cast iron
surfaces:
cast iron surface.
ground cast iron as a flaw, defect or scratches.
surfaces until the stains or rust is removed. Mak sure
scratching or marring the cast iron surface.
oil and dirt from the table saw using a soft cloth or rag.
to all unpainted cast iron surfaces. This will help to
protect the saw from rusting from further contact with
moisture or oily hands.
This table saw requires very little maintenance other than
minor lubrication and cleaning. The following sections
detail what will need to be done in order to assure
continued operation of your saw.
LUBRICATION
The table saw has sealed lubricated bearings in the
motor housing that do not require any additional
lubrication from the operator.
trunnions and apply a white lithium grease to keep them
lubricated.
MAINTAINENCE
CLEANING
Keep the inside of the cabinet clear of saw dust and wood
inside of the cabinet or blow out the inside with an air
as high pressure air may damage insulation.
WARNING
Be sure to wear protective eyewear and dust mask
when cleaning out the cabinet of the saw.
LOCATE YOUR SERIAL NUMBER
and serial number as reference.
33