Table of Contents
Advertisement
Intrepid® Direct Vent - Rear Vent Gas Heater
Fuel Conversion Instructions
WARNING! This conversion kit shall be installed
by a qualified service agency in accordance with
the manufacturer's instructions and all applicable
codes and requirements of the authority having ju-
risdiction. If the information in these instructions is
not followed exactly, a fire, explosion or production
of carbon monoxide may result causing property
damage, personal injury or loss of life. The qualified
service agency is responsible for the proper instal-
lation of this kit. The installation is not proper and
complete until the operation of the converted appli-
ance is checked as specified in the manufacturer's
instructions supplied with the kit.
CAUTION: The gas supply shall be shut off prior to
disconnecting the electrical power, before proceed-
ing with the conversion.
Gas Supply Inlet
Fig. 68 Attach the gas line to the right side of the valve.
Conversion Precautions
Before proceeding, turn control knob on valve to OFF and
ST226b
turn gas supply OFF. Turn OFF any electricity that may be
attach gas line
going to the appliance.
6/07 djt
Conversion Procedure
1. Remove stove front. Lift stove front up and then swing
bottom out and away to disengage from the stove body
(page 38, Fig. 82).
2. Swing open the swiveling latches at the top left and
right corners of the glass frame (page 38, Fig. 83).
3. Pull the top edge of the glass and frame assembly
away from the firebox face. Place the assembly out of
the way on a flat, padded surface such as a counter
protected by a towel.
4. Remove the logset from the firebox.
Valve Conversion
1. Turn control knob to the OFF position, and shut off the
gas supply to the valve.
2. Allow the valve to cool to room temperature.
3. Remove the black protection cap by hand. (Fig. 69)
34
4. Insert a 5/32" or 4 mm Allen wrench into the hexagonal
key-way of the screw (Fig. 70), rotate it counterclock-
wise until it is free and extract it.
5. Check that the screw is clean and if necessary remove
dirt.
6. Flip the screw. (Fig. 71)
7. Using the Allen wrench as shown in Figure 72, rotate
the screw clockwise and tighten until snug.
8. Verify that if the conversion is from NG to LP, the screw
must be reassembled with the red o-ring visible. (Fig.
73)
9. Replace the black protection cap.
Main
Gas Line
ST226b
Figure 69
CO138
remove screw
6/07
Figure 73
LP Configuration
Pilot Orifice Conversion
1. Locate pilot. (Fig. 74)
2. Replace pilot orifice.
Pilot Type 1
• Remove pilot hood by lifting up. (Fig. 75) Do not
remove snap ring to remove pilot hood. NOTE: It is
not necessary to remove the pilot tube for conver-
sion.
WARNING: Do not overtighten the screw. Rec-
ommended to grip the wrench by the short
side.
WARNING: Check that also the pilot and main
burner injectors are appropriate for the gas
type.
Figure 70
Figure 71
CO139
Allen wrench
CO140
6/07
turn screw
Natural Gas
6/07
Configuration
Red O-ring Visible
Red O-ring NOT Visible
CO141
O-ring configuration
6/07
Figure 72
CO139
Allen wrench
6/07
CO141
20306761
Advertisement
Table of Contents
