Table of Contents
Advertisement
Intrepid® Direct Vent - Rear Vent Gas Heater
Fuel Conversion Instructions
!
This conversion kit shall be installed by a qualified
service agency in accordance with the manufacturer's
instructions and all applicable codes and requirements
of the authority having jurisdiction. If the information
in these instructions is not followed exactly, a fire,
explosion or production of carbon monoxide may
result causing property damage, personal injury or
loss of life. The qualified service agency is responsible
for the proper installation of this kit. The installation
is not proper and complete until the operation of the
converted appliance is checked as specified in the
manufacturer's instructions supplied with the kit.
!
The gas supply shall be shut off prior to disconnecting
the electrical power, before proceeding with the
conversion.
Gas Supply Inlet
Figure 68 - Attach the gas line to the right side of the valve.
Conversion Precautions
Before proceeding, turn control knob on valve to OFF and
turn gas supply OFF. Turn OFF any electricity that may be
ST226b
going to the appliance.
attach gas line
Conversion Procedure
6/07 djt
1. Remove stove front. Lift stove front up and then swing
bottom out and away to disengage from the stove body
(page 38, Figure 82).
2. Swing open the swiveling latches at the top left and right
corners of the glass frame (page 38, Figure 83).
3. Pull the top edge of the glass and frame assembly away
from the firebox face. Place the assembly out of the way
on a flat, padded surface such as a counter protected by
a towel.
4. Remove the logset from the firebox.
Valve Conversion
1. Turn control knob to the OFF position, and shut off the
gas supply to the valve.
2. Allow the valve to cool to room temperature.
3. Remove the black protection cap by hand. (Figure 69)
3-90-20306761
WARNING
CAUTION
Main
Gas Line
Vermont Castings • Intrepid DV Owner's Manual_R3 • 12/16
4. Insert a 5/32" or 4 mm Allen wrench into the hexagonal key-
way of the screw (Figure 70), rotate it counterclockwise
until it is free and extract it.
5. Check that the screw is clean and if necessary remove
dirt.
6. Flip the screw. (Figure 71)
7. Using the Allen wrench as shown in Figure 72, rotate the
screw clockwise and tighten until snug.
!
Do not overtighten the screw. Recommended to grip
the wrench by the short side.
8. Verify that if the conversion is from NG to LP, the screw
must be reassembled with the red o-ring visible. (Figure
73)
9. Replace the black protection cap.
!
Check that also the pilot and main burner injectors
are appropriate for the gas type.
Figure 69
Figure 70
CO138
CO139
remove screw
Allen wrench
6/07
6/07
LP Configuration
Red O-ring Visible
Red O-ring NOT Visible
Figure 73
CO141
O-ring configuration
6/07
WARNING
WARNING
Figure 71
Figure 72
CO139
CO140
Allen wrench
Natural Gas
6/07
turn screw
Configuration
6/07
34
Hide quick links:
Advertisement
Table of Contents
