Fuel Conversion Instructions - Vermont Castings SDVR Series Homeowner's Installation & Operating Manual

Auto Path
If the manual switch is set
to REMOTE, press the
mode button to display
AUTO on the transmitter.
Does the transmitter dis-
play the room and tempera-
ture setting?
If the setting is above
room temperature on the
transmitter, does the main
valve and fan turn on?
If the settings is below
room temperature on the
transmitter, does the main
valve and fan turn off?
Turn pilotstat knob to OFF
to turn valve completely
off.

Fuel Conversion Instructions

WARNING! This conversion kit shall be installed
by a qualified service agency in accordance with
the manufacturer's instructions and all appli-
cable codes and requirements of the authority
having jurisdiction. If the information in these
instructions is not followed exactly, a fire, explo-
sion or production of carbon monoxide may
result causing property damage, personal injury
or loss of life. The qualified service agency is
responsible for the proper installation of this
kit. The installation is not proper and complete
until the operation of the converted appliance
is checked as specified in the manufacturer's
instructions supplied with the kit.
CAUTION: The gas supply shall be shut off prior
to disconnecting the electrical power, before
proceeding with the conversion.
20007066
Move switch
from LOCAL to
REMOTE. Press
any key within 30
seconds.
No
No
Pinnacle & Stardance Direct Vent - Rear Vent Gas Heaters
Fig. 56 Attach the gas line to the right side of the valve.
Conversion Precautions
Before proceeding, turn control knob on valve to OFF
and turn gas supply OFF. Turn OFF any electricity that
may be going to the appliance.
Conversion Procedure
1. Remove stove front. Lift stove front up and then
swing bottom out and away to disengage from the
stove body. (Page 37, Fig. 67)
2. Swing open the swiveling latches at the top left and
right corners of the glass frame. (Page 38, Fig. 68)
3. Pull the top edge of the glass and frame assembly
away from the firebox face. Place the assembly out
of the way on a flat, padded surface such as a coun-
ter protected by a towel.
4. Remove the logset from the firebox.
5. Remove the rear log bracket by unfastening the
screw. (Fig. 57)
6. Remove the right and left log bracket assembly by
unfastening the two screws which hold the burner in
place. (Fig. 57)
Remove Screws
Fig. 57 Remove rear log bracket and left and right log bracket
assembly.
ST350
Jefferson
air shutter adj
3/20/00 djt
Main
Gas Line
Gas Supply Inlet
ST226
attach gas line
12/8/99 djt
Rear Log Bracket
Pilot
Left & Right Log
Bracket Assembly
ST226
ST350
33