Fuel Filter; Fuel Solenoid Assembly; Injector Timing - Arctic Cat 2010 700 Diesel SD Service Manual

2. Connect the fuel inlet and lift pump outlet hoses to
the fuel lift pump using new crush washers and
secure with the banjo-fitting bolts. Tighten
securely.
Unit Injectors
To service the unit injectors, see Top-Side Components
in Section 3.

Injector Timing

NOTE: For injector timing instructions, see
Top-Side Components in Section 3.

Fuel Filter

To replace the fuel filter, see Section 2.
Back
DE530
DE078A
Manual
Table of Contents

Fuel Solenoid Assembly

NOTE: After troubleshooting the fuel solenoid
(see Section 5) if it is determined that replacement
is necessary, use the following procedure.
REMOVING
1. Remove the right-front inner splash panel; then
remove the V-belt cooling boot from the V-belt
housing.
2. Locate the fuel solenoid mounted on top of the
fuel filter head; then disconnect the spade connec-
tor from the solenoid.
3. Remove the banjo-fitting bolts (A) and (B) and
remove the fuel solenoid. Account for four crush
washers.
Section
Table of Contents
4
DE061A
DE647B
4-3
Next