Secondary Output Drive Gears - Arctic Cat 2010 700 Diesel SD Service Manual

8. Install the high driven gear thrust washer, bushing,
and bearing; then install the high driven gear and
thrust washer.
3-54
Back
DE189A
DE190A
DE191A
DE166A
Manual
Table of Contents
The countershaft is now assembled and ready for
installation.
AT THIS POINT
If the drive bevel gear assembly or secondary output
shaft assemblies were disassembled, use the follow-
ing procedure to assemble them.
SECONDARY OUTPUT DRIVE
GEARS
Initial Set-Up
NOTE: If the secondary output drive or driven
shaft is replaced or disassembled, the initial
set-up must be performed to establish correct gear
tooth contact. If only the secondary output driven
gear or shaft are replaced, proceed to Correcting
Backlash in this sub-section.
1. Install a new bearing (A) onto the secondary driven
shaft (B) making sure the bearing locating groove is
directed away from the driven gear splines.
Section
Table of Contents
DE655A
DE659A
Next