Main Bearing Seal Installation Tool - Arctic Cat 2010 700 Diesel SD Service Manual

2. Install the thrust bearing inserts into the rear main
bearing saddle using a small amount of oil-soluble
grease to hold them in place.
3. Install the lower main bearing inserts into the main
bearing caps; then install the thrust bearing inserts
into the rear main bearing cap using oil-soluble
grease to hold in place.
4. Apply a liberal amount of clean engine oil to the
crankshaft main bearing journals and the main
bearing saddles; then carefully install the crank-
shaft into the engine block.
Back
DE376A
DE628A
DE431
Manual
Table of Contents
5. Thoroughly coat the lateral seals with oil-soluble
grease; then install them in the front and rear main
bearing caps.
6. Using Main Bearing Seal Installation Tool or 0.07
mm (0.003 in.) shim stock as shown, slide the
main bearing cap into position in the main bearing
saddle being careful to keep the seals from sliding
out of place.
7. Remove the Main Bearing Seal Installation Tool
or shim stock; then install the main bearing cap
screws.
Section
Table of Contents
DE620A
3
DE431A
DE377A
3-69
Next