In-Line Fuel Filter; Maintenance - Arctic Cat AC 120 2007 Operator's Manual

2. Pull all slack from the throttle cable
wire and exert slight tension on the
wire.
3. Tighten the throttle cable wire
binding screw.
! WARNING
DO NOT operate the snowmobile
when any component in the throt-
tle system is damaged, frayed,
kinked, worn, or
adjusted. If the snowmobile is
operated when the throttle sys-
tem is not functioning properly,
personal injury could result.
Speed Control Screw
The maximum speed of the snowmobile
can be reduced by adjusting the speed
control screw.
To reduce the maximum speed, rotate
the speed control screw clockwise. DO
NOT EVER INCREASE THE MAXI-
MUM SPEED BEYOND THE ORIGI-
NAL 8 MPH MAXIMUM!

IN-LINE FUEL FILTER

Whenever any maintenance or
inspection is made on a fuel sys-
tem when there may be fuel leak-
age, there should be no welding,
smoking, open flames, etc., in the
area.
0735-459
Arctic Cat recommends that the in-line
fuel filter be checked once a month.
The filter is located in the fuel line
between the gas tank and carburetor.
The only cleaning possible is to back-
flush the filter using clean gasoline. To
check, clean, or replace the filter, use
the following procedure:
1. Turn the gas tank shut-off valve to
the CLOSED position.
2. Using a screwdriver, remove the
improperly
clamps; then pry the fuel hoses off
the in-line fuel filter and remove
the filter.
3. Install the in-line fuel filter in the
fuel hose so the arrow on the filter
points toward the carburetor. Make
sure the fuel hoses fit tightly on the
filter. If a fuel hose does not fit
tightly, cut 6 mm (1/4 in.) from the
end of the fuel hose; then install on
the filter. Install the clamps.
The fuel hoses must fit tightly on
the fuel filter. If the fuel hose
length doesn't permit this proce-
dure, replace the fuel hose. Also,
after installing the fuel hoses on
the filter, check to be sure that
the fuel hoses do not contact any
hot or rotating components.
! WARNING
! CAUTION
11