Technical Specification - Pinguino PAC AN130ES Instructions For Use Manual

TECHNICAL CHARACTERISTICS:
Power supply voltage
Max. power input
during air conditioning
Max. power input
during heating
Refrigerant
Cooling capacity
Transport, filling, cleaning, recovery and disposal of refrigerant should be performed by a tech-
nical service centre appointed by the manufacturer only.
The appliance should be disposed of by a specialist centre appointed by the manufacturer only.
NEVER TRANSPORT OR TURN THE APPLIANCE UPSIDE DOWN OR ON ITS
SIDE. IF THIS OCCURS, WAIT 6 HOURS BEFORE TURNING THE APPLIANCE
ON, 24 HOURS IS RECOMMENDED. (After the unit has been on its side,
oil needs to return to the compressor to ensure proper function.
Without allowing the unit this time (6-24 hours) The unit may function
for only a short time, and then the compressor will break down from
lack of oil).
This appliance is equipped with a 3 prong grounded plug. The plug must be connected
into an outlet that is properly installed and grounded in the accordance with all local
codes and ordinances. Do not modify the plug provided with the appliance. If it will not
fit the outlet, have a proper outlet installed by a qualified electrician or relocate the unit
to a proper outlet.
If the household electrical supply does not meet the above specifications, or if you are
not sure your home has an effective electrical ground, have a qualified electrician or
your local electrical utility company check it and correct any problems.
SAFETY PLUG
The appliance is fitted with a safety plug to protect the power cable.
If power is cut off, unplug from the outlet and make sure the power cable is undamaged.
If the cable is damaged, call the service center immediately.
If power cuts off frequently and the power cable is undamaged, contact a qualified elec-
trician.
OPERATION OF THE SAFETY PLUG
If the safety device incorporated in the plug trips and cuts off the power supply, check
that the power cable and plug are not damaged.
If the power cable is undamaged, to restore operation press the "RESET" button.
To verify correct operation of the plug, press the "TEST" button periodically and make sure
the appliance disconnects. If this is not the case, contact the service center.
To restore operation, press the "RESET" button.
16
pecifi
Technical s
see rating plate
"
"
"
"
cation
LIMIT CONDITIONS
Room temperature for air
conditioning (with fans
at maximum speed) 64 ÷ 104°F
18 ÷ 40°C