Cleaning The Cabinet; Start Of Season Checks; End Of Season Operations - Pinguino PAC AN130ES Instructions For Use Manual

Before cleaning or maintenance, turn the
appliance off by pressing the ON/OFF button (A)
or in models with remote control, by pressing the
20
, then always unplug the
ON/OFF button
appliance from the electrical receptacle.

CLEANING THE CABINET

You should clean the appliance with a slightly
damp cloth then dry with a dry cloth. For
safety reasons, never wash the air conditioner
with water.
Precautions
Never use petrol, alcohol or solvents to clean
the appliance. Never spray insecticide liquids
or similar.
CLEANING THE SILVER ION AIR FILTER
If the filter is dirty, air circulation is compromi-
sed and the efficiency of the appliance
decreases.
It is therefore good practice to clean the filter
at regular intervals. The frequency depends
on the duration and conditions of operation.
If the unit is used constantly or systematically,
you are recommended to clean the filter
once a week.
The filter is housed in the intake grille.
To clean the filter, extract as shown in fig. L.
Use a vacuum cleaner to remove the dust
collected on the filter. If it is very dirty, immer-
se in warm water and rinse a number of times.
The water should never be hotter than 104°F
40°C.
14
C l e a n i n g
After washing the filter, allow it to dry comple-
tely before repositioning it.
The silver ion filter not just retains dust parti-
cles, but also has an efficient antibacterial
action. It also greatly reduces concentrations
of irritants such as pollen and spores.

START OF SEASON CHECKS

Make sure the power cable and plug are
undamaged and the ground connection is
efficient. Follow the installation instructions
precisely.

END OF SEASON OPERATIONS

To drain all water from the circuit, remove the
external cap by unscrewing it in the anti-
clockwise direction then, remove the internal
cap from the drainage
the appliance and allow the water to drain
out into a basin (figure M).
When the appliance is empty, replace the
caps.
Clean the filter and dry thoroughly before
putting back.
L
10
on the back of
M