Safety And Compliance - MakerBot Replicator Z18 User Manual

SAFETY AND COMPLIANCE

RADIO AND TELEVISION INTERFERENCE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the Federal Communications Commission (FCC) rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
You may also find helpful the following booklet, prepared by the FCC: "How to Identify and Resolve
Radio-TV Interference Problems." This booklet is available from the U.S. Government Printing Office,
Washington, D.C. 20402.
Changes and modifications not expressly approved by the manufacturer or registrant of this equipment
can void your authority to operate this equipment under FCC rules.
MANUFACTURER
MakerBot Industries, LLC
One MetroTech Center, 21st Floor
Brooklyn, NY 11201
347.334.6800
WIRELESS SPECIFICATIONS
WLAN RF Antenna
Frequency Frequency Range Protocol Antenna Type Specifications
Taoglas, part # 2.5 dBi in the 2.4
2.4 GHz 2.412 - 2.472 GHz 802.11 b/g/n FX831.07.0100C GHz band
7
WELCOME.