MakerBot Replicator Z18 User Manual page 8

SAFETY AND COMPLIANCE
Safety alert symbols
potential safety hazards that could harm you or others or cause product or property damage.
Warning:
The MakerBot Replicator Z18 generates high temperatures. Always allow
the MakerBot Replicator Z18 to cool down before you reach inside.
Warning:
The MakerBot Replicator Z18 includes moving parts that can cause injury.
Never reach inside the MakerBot Replicator Z18 while it is in operation.
Warning:
There is a risk of shock. The MakerBot Replicator Z18 is not user serviceable.
Caution:
Avoid leaving the MakerBot Replicator Z18 unattended during operation.
If you must leave the MakerBot Replicator Z18 unattended during a print, exercise
caution and follow these guidelines:
•
• Verify that the MakerBot Replicator Z18 has started the print and is
operating normally.
• • Ensure that filament is wound tightly on the spool, free of tangles
•
and feeding properly.
•
• Monitor your print periodically.
•
• If possible, monitor your print via the on-board camera.
•
Caution: Two people are required to lift the MakerBot Replicator Z18. Do not lift
alone. To prevent injury, lift with your legs, not your back.
Caution:
Do not print using materials that have not been approved by MakerBot for
use with the MakerBot Replicator Z18. Refer to the Specifications section on page 61
for more information.
8
WELCOME.
precede each safety message in this manual. These symbols indicate