Safety And Compliance - MakerBot Replicator 2 User Manual

http://www.monomachines.com/

SAFETY AND COMPLIANCE

6
http://www.monomachines.com/
Safety alert symbols precede each safety message in this manual.
These symbols indicate potential safety hazards that could harm you
or others or cause product or property damage.
WARNING: The MakerBot Replicator 2 Desktop 3D Printer generates high
temperatures. Always allow the MakerBot Replicator 2 to cool down before
reaching inside.
WARNING: The MakerBot Replicator 2 includes moving parts that can cause
injury. Never reach inside the MakerBot Replicator 2 while it is in operation.
WARNING: Do not leave the MakerBot Replicator 2 unattended during
operation.
CAUTION: Use caution when printing with materials that have not been
approved by MakerBot for use with the MakerBot Replicator 2.
CAUTION: In case of emergency disconnect power supply from wall socket.
CAUTION: The socket outlet must be located near the equipment and must
be easily accessible
CAUTION: The Replicator 2 melts plastic during printing. Plastic odors are
emitted during this operation. Make sure to set up the Replicator 2 in a well-
ventilated area.
For More Info
Click Here --->