Epson Stylus CX4900 Service Manual page 137

EPSON Stylus CX4900/CX4905/CX5000/DX5000/DX5050/CX5900/CX6000/DX6000/DX6050
External view (2)
1
C.B.P. 3x10 F/Zn
(4±1kgfcm)
C.B.P. 3x8 F/Zn
(4±1kgfcm)
Tab
Holding Positions
Front Paper
Guide Support
Guide Pin
PG Lever Groove
Figure 4-15. Removing Printer Mechanism (2)
DISASSEMBLY/ASSEMBLY
2
4
Printer Mechanism
CR Guide Frame
5 6
Main Board
CN1
PS Connector Cable
4. Remove the screws (x6,
5. Disconnect the PS Connector Cable from the connector (CN1) of the Main
Board.
Hold the designated position and lift Printer Mechanism upward
C A U T I O N
when performing the following step in order to prevent warping of
Main Frame.
3
6. Hold up the left side of the Printer Mechanism while releasing the guide pin of
the Front Paper Guide Support from the groove of the PG Lever with a
precision screwdriver (-), and remove whole Printer Mechanism from the
Housing, Lower.
When installing the Printer Mechanism to the Housing, Lower,
W A R N I N G
insert the Waste Ink Tube to the Waste Ink Cover and securely
fasten the Waste Ink Tube with the Tube Stopper, or ink may leak
from the Tube.
When installing the Printer Mechanism to the Housing, Lower,
match the guide pin (x1,
positioning hole (x1) of the Printer Mechanism.
Tighten the screws in the order as shown in the figure.
When installing the Rear Cover, match the tabs (x2,
Rear Cover with the notches (x2) of the Housing, Lower.
When installing the Waste Ink Tube, insert the tube
(T.B.D)
Tube Stopper
Waste Ink Tube
Printer Section
) that secure the Printer Mechanism.
) of the Housing, Lower with the
into the Waste Ink Cover as shown below.
54 ± 1mm
Figure 4-16. Installing Waste Ink Tube
Revision A
) of the
54 ± 1 mm
Waste Ink Cover
137