Chapter 3 Troubleshooting; Ej Frame Unit - Epson Stylus CX4900 Service Manual

EPSON Stylus CX4900/CX4905/CX5000/DX5000/DX5050/CX5900/CX6000/DX6000/DX6050

4.4.23 EJ Frame Unit

External view (1)
Bush 5
Acetate
Tape
Left Side
Paper Eject
Grounding Spring
Figure 4-44. Removing EJ Frame Unit
DISASSEMBLY/ASSEMBLY
Bush 5
Right Side
EJ Frame Unit
Tabs
Printer Section
Part/Unit that should be removed before removing EJ Frame Unit
Document Cover / Panel Unit / Scanner Unit / Housing, Upper / Housing, Lower /
Main Board Unit / CR Guide Frame / CR Motor / CR Scale / Carriage Unit / Front
Frame
Removal procedure
Do not hold the EJ Frame Unit while handling the Printer
C A U T I O N
Mechanism in your repair.
Do not touch the rubber portion of the Eject Roller.
1. Peel off the acetate tape (x1) that secures the PG Sensor Connector Cable.
2. Remove the Paper Eject Grounding Spring from the left side of the EJ Frame
Unit.
3. Release the guide pin (x1, ) of Bush 5 on the left side of the EJ Frame Unit,
and rotate the Bush 5 downward by 90°.
4. Release the guide pin (x1, )of Bush 5 on the right side of the EJ Frame Unit,
and rotate the Bush 5 upward (or downward) by 90°.
5. Release the tabs (x3, ) that secure the EJ Frame Unit while lifting the near
side of the EJ Frame Unit upward.
Revision A
159