Table of Contents
Advertisement
Handling Instructions
Black Enamel Panels
•
Black Enamel panels must be inspected for scratches and
dimples prior to installation. All claims to be recorded at this time.
Claims for damage after installation will not receive consideration.
•
Black Enamel panels will discolor a little during normal operation.
This
is normal and should not be considered a defect.
*
All hand and fi nger marks MUST be cleaned off with a soft cloth.
Use an ammonia based cleaner (ie. glass cleaner) to remove any
fi ngerprints before applying heat to the unit.
Failure to do this will result in burn stain on panels which you
will be unable to remove. Not protected by product warranty.
1) Remove the faceplate and glass door if already installed - see
manual for instructions.
2) Remove 4 screws to remove top heat defl ector.
3) Remove installed factory panels.
Loosen 2 screws (do not remove) on panel clip securing side panel,
Slide panel clip down away from screws.
Remove side panel.
4) Repeat on opposite side.
5) Remove back panel.
6) Install the back enamel panel fi rst. Tilt the panel forward - position
the bottom of the panel fi rst. Use care not to scratch or mar the panel
on the pilot shield.
Regency Horizon™ HZ40E-2 Gas Fireplace
INNER PANEL INSTALLATION
7) Install the left side enamel panel - secure in position with the panel
9) Reinstall heat defl ector.
10) Reinstall glass door - reinstall faceplate.
panel clip
clip and two tighten two screws loosened in step 2, as shown in the
diagram below.
8) Install the right side enamel panel - secure in position with the panel
clip and two screws loosened in step 4.
Final Install
INSTALLATION
49
Advertisement
Table of Contents
