Table of Contents
Advertisement
INSTALLATION
Optional
REMOTE CONTROL
Use the Regency
®
Remote Control approved for this unit. Use of other systems
may void your warranty.
The remote control comes with a hand held transmitter.
*Profl ame GT remote control 946-700
RF remote, ON/OFF Thermostat, ON/OFF Flame Control
Large blue backlit LCD screen with temperature display receiver.
*Profl ame GTM remote control 946-701.
RF remote, ON/OFF Thermostat, ON/OFF Flame Control
Large blue backlit LCD screen with temperature display receiver.
**Profl ame GTMF remote control 946-702.
RF remote, ON/OFF Thermostat, ON/OFF Flame Control
ON/OFF fan control with 3-stage adjustment. Requires a fan (if not included),
to be installed for fan function to operate.
*Must also chose one of the following which enables the fl ame to be turned
down using the remote control:
*Modulator Surefi re NG 946-693
*Modulator Surefi re LP 946-694
Large blue backlit LCD screen with temperature display receiver.
42
RECEIVER WALL SWITCH
(Included with Unit)
1) Run the supplied 10' of the wire harness through the right or left side gas
inlet opening- connect the ON/OFF wire harness. Be careful not to damage
wire.
2) Choose a convenient location on the wall to install the receiver and the
receptacle box (protection from extreme heat is very important). Run wires
from the fi replace to that location.
3) Connect the wire to the receiver wall switch and install into the low voltage
receptacle box.
Regency Horizon™ HZ40E-2 Gas Fireplace
Advertisement
Table of Contents
